→ My Lesson → Start Learning / Download MP3 Flashcards

start learning

Question		Answer
emergency engine shut down on the ground start learning		PCL - OFF; FIREWALL SHUTOFF HANDLE - PULL
abort start learning		PCL - IDLE; BRAKES - AS REQUIRED
engine failure immediately after takeoff (sufficient runway remaining straight ahead) start learning		AIRSPEED - 110 KNOTS (MINIMUM); PCL - AS REQUIRED; EMER LDG GR HANDLE - PULL (AS REQUIRED)
engine failure during flight start learning		ZOOM/GLIDE - 125 KNOTS; PCL - OFF; INTERCEPT ELP
immediate airstart (PMU NORM) start learning		PCL - OFF; STARTER SWITCH - AUTO/RESET; PCL - IDLE, ABOVE 13% N1
Uncommanded power changes/ loss of power/ uncommanded propeller feather start learning		PCL - MID RANGE; PMU SWITCH - OFF; PROP SYS CIRCUIT BREAKER (left front console) - PULL, IF NP STABLE BELOW 40%
inadvertent departure from controlled flight start learning		PCL - IDLE; CONTROLS - NEUTRAL; ALTITUDE - CHECK
Fire in flight if fire is confirmed start learning		PCL - OFF; FIREWALL SHUTOFF HANDLE - PULL
OBOGS inoperative start learning		GREEN RING - PULL (AS REQUIRED)
eject start learning		EJECTION HANDLE - PULL
engine maximum torque takeoff/max start learning		100%
engine maximum torque transient start learning		131% (20 seconds)
engine torque indicative of a system malfunction start learning		102%
engine maximum ITT idle start learning		750 °c
engine maximum ITT takeoff/max start learning		820 °c
engine maximum ITT transient start learning		870 °c (up to 20 seconds)
engine N1 idle ground start learning		60 to 61%
engine N1 idle flight start learning		67% min
engine NP idle start learning		46 to 50%
engine takeoff/max start learning		100% (100% +- 2% PMU off)
engine NP avoid stabilized ground operations from start learning		62 to 80% NP
engine oil pressure takeoff/max start learning		90 to 120 PSI
engine oil pressure aerobatucs/spins start learning		40 to 130 PSI
engine oil pressure aerobatic/spins (idle) start learning		15 to 40 PSI (5 sec)
engine oil temp takeoff/max start learning		10 to 105 °c
engine oil temp transient start learning		106 to 110 °c (10 minutes)

My lesson

You must sign in to write a comment

More